22 mm Thick, 6mm Oak Wear Layer, 189mm Width & 1860mm Length Boards. 22×189 Thru Flow Brushed & Natural Oiled Birch Backed, Is Designed For Underfloor Heating.
Brushed and natural oiled engineered oak flooring with 100% birch plywood backing is not only a stunning oak floor for any home or venue but also provides fantastic stability and strength to your floor after installation. The birch plywood backed brushed and natural oiled is one of our most popular engineered oak floors and is specially designed for in areas where extra stability may be required.
This engineered birch backed oak flooring is 22mm thick, which is made up from 16mm of birch plywood underside that is fully bonded to a full 6mm of French oak wear layer that fully covers the face of the board as a 189mm wide single strip oak. This impressive coverage showcases the extra width available when ordering from our engineered oak flooring range.
The brushed and natural oiled finish is achieved by ‘brushing’ the face of the oak planks during manufacture, removing the slightly softer fibres of the oak from the board. After the oak has been brushed, it is then oiled, creating a slightly textured finish to the flooring.
The finish of this floor is very easy to maintain and should only ever require a light sanding and another coat of waxoil to bring it back to pristine condition (depending on wear and tear).
More efficient over Underfloor Heating (UFH) than a standard 20mm or 21mm engineered products. This unique and exclusive product has been designed for use specifically with Underfloor Heating (UFH), having a pre-drilled plywood underside that allows the heat from the UFH to travel through it more easily. This results in the heating efficiency being improved and a considerable saving on the cost of heating.
Our ThruFlow brushed and natural oiled heat efficient flooring is the only flooring available that will eventually pay for itself from the savings made to your heating bills.
Even after the plywood underside is drilled for better heat efficiency, the overall strength still remains as being more than 50% higher than the required standard, which results in it being classed as structural grade. This means that it can be installed over supports like joists or battens without further support, as long as those joists or battens are fixed themselves at centres of no more than 400mm.
|Product||22(6)x189 Thru-Flow Brushed & Natural Oiled Oak Flooring – Birch Backed|
Brushed & Oiled, finished with natural colour Waxoil
Approx 85% @ 1830mm long, 15% shorter
|Oak Wear Layer||
6-9% on arrival to site.
6mm Oak on 15mm Eucalyptus plywood: structural
TG4: T&G sides & ends, all micro bevelled
|Carton Size and Weight||
1860 x 195 x 140 weighing 30kg each
|m2 Per Carton||
|m2 Per Pallet||
72.8 (35 cartons)
Float, Glue Down, Nail/Screw Down
|Suitable for UFH?||